Mitsubishi PLC FX2N HMI E1000 Networking using BDTP Technology

Networking between E1000 terminals using BDTP Technology.      

 1.   Material Requirement

The required material for the setup is as follows

Sr. no.	Material
1	PLC Type  : FX Series
2	CPU         :  FX2N
3	PLC S/W   : GX Developer Ver. 8.45X
4	HMI          : E1041,E1043
5	Other

 2. Diagram

 

Network communication via BDTP is used to connect two or more E1000-series operator terminals to one or two controllers or several operator terminals to two or more controllers, with retained performance.

Figure 1 Networking between E –Terminals using BDTP Technology

 Cables

The required cables are as follows

    

Sr. no.	Item	Description
1	Medoc cable	Prog. cable for FX PLC
2	Ethernet Cross Cable	Comm. Cable for E-Terminal to E-Terminal & PLC*1

*1 To connect the E-Terminal to E-Terminal if HUB is used then Serial    Straight cable is used.

  

4.  E-Designer Program Setting

 Set IP 192.168.1.1 of BDTP Server in Peripheral Configuration as below.

Fig: Peripheral Configuration of BDTP Server

 Network Connection/Network services:

Select Network Services, Select BDTP Server to edit Max Client.

 

Fig. Network Connection of BDTP Server

 

Fig. Network services of BDTP Server

   5.  BDTP Client Setting

  

   Set IP 192.168.1.2 of BDTP Client as below

Fig: Peripheral Configuration of BDTP Client

  5.  BDTP Client Setting

For the network service BDTP Client, the IP Addresses for the BDTP Servers in the network from which the client is to collect information are defined. Select BDTP Clientin the list and click Edit to enter the settings.

 

Fig. Network services of BDTP Client

Related Posts by Categories